Cat 6 Outdoor Ethernet Cable 35ft

Getting the most from it

A network connection that stops at the wall can make it awkward to reach a backyard office, outdoor camera, or router placed away from the house. This 35-foot Cat 6 Ethernet cable is designed for outdoor routing and direct burial, with an LLDPE jacket described as resistant to water, UV exposure, and abrasion. Its RJ45 connectors make it a plug-in option for compatible network equipment, while the cable can be routed between indoor and outdoor devices without leaving a loose line across a walkway.

For example, you could run it from a router toward a low-power PoE camera at the edge of a yard, then connect the RJ45 end to the camera. The cable is unshielded, with four twisted pairs intended to help limit interference.

If you prioritize an outdoor-ready jacket and a direct route between devices, this format makes sense, if you prefer a cable for demanding PoE loads, the conductor material deserves more attention. The listing identifies the conductors as 24AWG copper-clad aluminum (CCA), and recommends this cable for low-power PoE rather than high-power devices. Check the device requirements before relying on it to carry both power and data.

Why it’s worth it

The useful distinction here is its intended installation, not just its Cat 6 label. The LLDPE jacket is specified for outdoor and in-ground use, including exposure to sun and rain, so it is aimed at a run that ordinary indoor patch cable may not be suited to. At 35 feet, it can bridge a modest gap without joining multiple short cables, which also avoids putting a connection point mid-run.

The listing claims speeds up to 10 Gbps and 550 MHz bandwidth. Treat those as stated capabilities, not a guarantee that every connected device or network will reach that speed. Performance depends on the rest of the setup. The cable also supports Cat 8, Cat 7, Cat 6, and Cat 5e devices with RJ45 ports, according to the product details, and is listed for use with routers, switches, computers, and other network equipment.

It’s a great fit if you need one outdoor run for a compatible router, access point, or low-power camera. It’s not for you if your installation calls for high-power PoE or if you specifically want conductors made from solid copper. That CCA limitation is the key buying trade-off, even though the cable is presented as a cost-conscious option for Cat 5e and Cat 6 networks.

Key takeaways

• 35-foot Cat 6 cable with an LLDPE jacket for outdoor routing and direct burial.
• 24AWG CCA conductors, four unshielded twisted pairs, and RJ45 connectors.
• The listing states support for up to 10 Gbps and 550 MHz, actual network speed also depends on connected equipment.
• PoE is supported, but the product details recommend low-power use and advise checking compatibility for high-power devices.

The jacket and length are the practical reasons to choose this over a basic indoor patch cord. For a more demanding PoE setup, choosing a cable specifically suited to that power requirement is the safer approach. On the spec sheet, the headline speed looks appealing, but it should not outweigh the stated CCA limitation when power delivery is part of the job.

Buying verdict

This cable is worth considering when you need a single 35-foot connection for an outdoor or buried network run and your equipment uses a compatible RJ45 connection. Its weather-resistant jacket gives it a clearer role than a standard indoor cable, particularly for connecting a router to an outbuilding or a low-power outdoor device. The main reason to pass is straightforward: CCA conductors make it a poor match for high-power PoE needs. If your setup is low-power and the length fits the route, its intended use is easy to understand, if power demands are higher, choose around that requirement instead of relying on the speed claim alone.