Zayejod 1 L-shaped Shower Threshold Barrier, 2 m, White

If you need to keep shower water within a wet-room area or away from a bathroom threshold, this Zayejod L-shaped barrier creates a raised edge along the floor. Its 2 m length can be cut to suit the section you want to protect, making it useful beside a shower tray, under a shower curtain or around a bath edge.

The white strip has a 16 mm wide by 30 mm high profile and can be shaped around curved areas. It is also suited to other smooth surfaces where water needs to be contained, such as beside a basin or washing machine.

Worth noting

This is a practical alternative to adding a fixed raised shower kerb: the flexible strip can be positioned along the edge where water tends to spread, while keeping the floor-level layout. It is designed for smooth, flat surfaces such as tile, glass or ceramic. For a neat corner, the fitting instructions recommend cutting the adjoining pieces at 45 degrees before joining them.

Buyer feedback is mixed. Some customers say the barrier does its job, while others report that the adhesive does not hold well and that the strip can be difficult to keep flat at corners or ends. Careful preparation and a gradual, well-pressed installation are therefore important parts of getting a tidy fit.

Cleaning & care

For everyday cleaning, wipe the strip with a damp cloth. Keeping the surface clean also helps maintain a neat finish around the shower or bath. After installation, leave the sealant to dry before the area gets wet, the stated drying time is 24 hours, with extra time recommended in autumn and winter.

Getting the most from it

Measure the section first and cut the strip to the required length. Clean and dry the floor, then mark the intended position. Peel the adhesive backing away gradually as you apply the barrier, pressing each section onto the surface rather than removing the full backing at once. This helps you keep the strip aligned as it goes down.

For a lasting seal, apply silicone sealant along the bottom edge and at both ends, then smooth away any excess. Silicone sealant is not included, so have it ready for the installation. Keep the area dry while the sealant sets. What makes this fitting method useful? It lets you adapt the barrier to a particular edge instead of relying on a single fixed-length piece.

Before you decide

How long is the barrier? It is 2 m long and can be cut to the length needed for your installation.

What surfaces is it suitable for? It is intended for smooth, flat surfaces, including tile, glass and ceramic. Clean and dry the surface before applying it.

Should I use silicone sealant as well as the adhesive backing? Yes. Apply sealant along the bottom and around the ends for a secure, sealed finish, then allow it to dry for 24 hours before the area gets wet. The sealant is not included.

Final verdict

It’s a good fit if you want a cut-to-length water barrier for a shower entrance, bath edge or another smooth floor area where water needs to stay contained. The flexible L-shaped profile, 2 m length and option to form corners make it a useful choice for tailoring the barrier to the layout of your bathroom.