Asidrama cabinet pulls, 4-inch spacing

Replacing cabinet hardware can turn into a small project if the new pulls do not line up with the existing holes. These Asidrama handles use a 4-inch (102 mm) hole spacing, so they may suit a straightforward swap where that measurement already matches.

The brushed satin nickel finish gives drawers and cupboard doors a consistent metal look. Each pull is individually packaged, which may help protect the finish before installation.

The set contains 10 pulls made from zinc alloy. The listing also gives the overall length, width and projection, useful details when you are checking how the handles will sit against your cabinet fronts.

Size and fit

The key measurement for a replacement is the distance between the two screw holes, not the handle’s full length. These pulls have 4-inch (102 mm) hole centres and an overall length of 4.5 inches (115 mm). They are 0.4 inches (10 mm) wide and project 1.4 inches (35 mm) from the surface.

For example, if a kitchen drawer already has two holes 4 inches apart, this size could let you replace the old pull without changing their positions. If your existing hardware uses a different spacing, a new set of holes may be needed, that adds work and may not suit a simple hardware refresh. The product details do not specify screw lengths, so check what is needed for your cabinet thickness before starting.

Pros

• A 10-pack gives you matching pulls for several cabinets or drawers.
• The stated 4-inch (102 mm) hole spacing is useful when matching existing hardware.
• Zinc alloy construction and a brushed satin nickel finish are specified.
• The listing describes these pulls for cabinets, cupboards, drawers, closets, dressers, doors and wardrobes.

One practical plus is having the same finish across a run of kitchen drawers instead of mixing replacement handles with older, mismatched hardware. The trade-off is that this is a fixed-size pull: it will not solve a spacing mismatch by itself. It makes sense if you want a coordinated set and your planned locations suit the listed dimensions. It’s not for you if you need a different hole spacing or a handle in another finish.

Spec sheet

• Type: Cabinet pull
• Pack size: 10
• Material: Zinc alloy
• Finish: Brushed satin nickel
• Hole centres: 4 inches (102 mm)
• Overall length: 4.5 inches (115 mm)
• Width: 0.4 inches (10 mm)
• Projection: 1.4 inches (35 mm)

The listing says the manufacturer will replace the product or provide a full refund for quality problems within its stated 100-day guarantee. That is a specific claim in the product information, rather than a reason to overlook the measurements: fit is still the main decision point.

What I’d decide

Choose these if you want a matching brushed satin nickel set and the 4-inch hole centres work for your cabinets. Compared with buying a single replacement or choosing new hardware that requires a different drilling layout, a 10-pack is geared towards updating several pieces together. The given dimensions make the fit easier to assess, but they do not tell you whether the pulls will feel right on every door or drawer. If you are planning a larger refresh, measure each location first, if you only need one handle or your existing holes differ, a different size or pack format may make more sense.