FANEAMADE Dryer Thermal Fuse WP3392519

For someone troubleshooting a Whirlpool, Maytag, or Kenmore dryer that has stopped heating or starting, this three-pack offers replacement fuses for specific models that use the 3392519 series. A blown thermal fuse can be the cause of those symptoms, but the part only fits dryers that call for a matching fuse. Check the number on the old part and your full dryer model before choosing it, this is an aftermarket replacement, not an original OEM component.

Technical details

The pack contains three white-housing thermal fuses. The main replacement number is WP3392519, and the listed equivalents are 3392519, 694511, 80005, AP6008325, G4AP0500, and 3388651. The fuse has two quick-connect terminals and mounting holes laid out to match the original part. It is listed for gas and electric dryers, but only when the dryer specifies a fuse from this series.

Its role is to cut power when the dryer exhaust gets too hot. If a dryer runs without heat, will not start, or stops during a cycle, a failed fuse is one possible cause—not a guarantee that replacing it will solve every fault. The three-pack leaves spares on hand, though the extra fuses are not a substitute for finding out why the original failed.

Everyday compatibility

Compatibility depends on the dryer’s full model and the part number, not just the brand name. Whirlpool, Maytag, and Kenmore appear in the fit information, but dryer generations differ. Match the number printed on the existing fuse against the listed replacements, then confirm the full model calls for that part. A familiar brand by itself is not enough to establish fit.

This replacement may suit a household that wants the part available before opening the dryer, or someone maintaining more than one compatible machine. For a single repair, a one-piece replacement may be a better fit if keeping spares has no value to you. Either way, confirming the part number matters more than buying by symptom alone.

Usage tips

The described DIY process starts with unplugging the dryer, then removing the lower or rear panel to reach the fuse. Move the two wires to the replacement one at a time and fasten it in place. The listing describes the job as taking about 15 minutes and requiring no special tools beyond a screwdriver or nut driver, actual access can vary by dryer. If you are not comfortable opening the appliance, do not treat that estimate as a reason to rush.

A blocked vent is identified as the usual cause of a blown fuse. Clear lint from the vent and ducting when replacing it, rather than fitting a new fuse and leaving a possible overheating cause in place. Picture a load stopping mid-cycle with damp clothes inside: checking the vent alongside the failed fuse can help address the problem that may have triggered the shutdown.

Questions before you buy

Does this fit every Whirlpool, Maytag, or Kenmore dryer? No. It is intended for models that specify a 3392519-series fuse. Confirm both the old part number and the full dryer model.

Is it an OEM part? No. The listing identifies it as an aftermarket replacement.

Why are there three fuses? The pack includes spares. If a fuse has blown, the vent and ducting should also be checked for lint or blockage.

When it makes sense

It suits you if your dryer’s model and existing fuse number match the listed compatibility information, and you want spare fuses for later. Not the best choice if you are relying on the brand name alone, or if you need an OEM component. This is a targeted repair part, not a general fix for every no-heat or no-start problem, match first, then address the vent condition that may have caused the fuse to fail.