What it is and what it’s for\nERMWALR offers a 20-piece set of wheel bolts designed to fit alloy wheels on Audi, VW, Seat and Skoda vehicles, matching OE specification WHT 002 437. These are M14 x 1.5 bolts with a 27mm thread length and a 17mm hex head, intended to secure alloy wheels to the hub. On paper, they provide a direct replacement option that can help maintain correct wheel alignment and fitment when you’re replacing worn bolts or upgrading to a matching set.\n\n## How they’re built\nManufactured from high-strength carbon steel (Grade 10.9) and finished with bright zinc plating, the bolts are hardened for corrosion and rust resistance and improved durability. The combination aims to offer robust fracture resistance for everyday driving and routine maintenance. While the plating adds protection, it’s reasonable to expect wear over time under harsher road conditions or frequent wheel changes.\n\n## What stands out and what might be a limit\nOn the plus side, the set is described as an OE-spec replacement, which means the diameter, seat type and thread pattern are aligned with the original hardware used on the approved models. The 48mm overall length, 27mm thread length and 23mm bolt width are stated dimensions that matter for ensuring proper fit. A potential caveat is the note about manual measurement errors—sizes can vary slightly in practice, so it’s prudent to verify your vehicle’s needs before purchase.\n\n## Who it’s for\nThis set suits owners looking for a practical, affordable replacement to keep wheel mounting consistent with the car’s original design, particularly those maintaining Audi, VW, Seat or Skoda models with the WHT 002 437 OE number. It’s appropriate for everyday drivers who want reliable hardware without venturing into high-end, performance-focused options.\n\n## Who it isn’t for\nIf you’re after ultra-lightweight or premium-grade fasteners for high-performance driving or racing, this Grade 10.9 zinc-plated option may not meet those specific demands. For vehicles outside the listed OE references, compatibility cannot be assumed.\n\n## When to buy\nConsider this set if you need a close OE match to replace worn or missing bolts on compatible models, and you value a straightforward, corrosion-resistant solution that’s easy to source as a 20‑piece pack. It’s sensible to check that your vehicle and OE numbers align before ordering to avoid ordering errors.\n\n## What to check before buying\n- Confirm your vehicle model matches Audi/Seat/Skoda/VW with OE WHT 002 437.\n- Double-check bolt length, thread pitch (M14 x 1.5) and hex size (17mm) against your current hardware.\n- Be aware that measurements can have small variances due to manual sizing.\n\n## Practical use scenario\nImagine performing routine wheel maintenance after a winter with salted roads. You pull out a known-good set of replacement bolts, fit them to the hub, and torque them to the car’s spec. The zinc finish helps resist moisture exposure, and the 17mm hex makes it straightforward to tighten with standard tools, ensuring secure wheel mounting during the next few seasons.\n\n## Final decision — Is it worth it?\nIt makes sense if you need OE-grade replacements for compatible Audi/VW group models and value a durable, corrosion-resistant finish at a sensible price. Not the best choice if you require specialised racing hardware or if your vehicle isn’t among the stated OE references.\n\n## FAQ\n- Will these bolts fit my car? They’re intended as replacements for models aligned with OE WHT 002 437, verify your vehicle and OE numbers before purchase.\n- Are they corrosion resistant? Yes, a bright zinc coating provides improved corrosion resistance for regular road use.\n- What is the corresponding seat type? The bolts have a radius seat with a 17mm hex head.\n- How many bolts come in the pack? 20 pieces are included in the set.
