Awning Tie Down Kit with Storm Straps for Thule Omnistor Awnings
Product description
What it is and who it’s for
This is a premium tie-down kit designed to work with Thule Omnistor motorhome awnings. If you’re looking to add reinforced stability to your caravan or motorhome in exposed conditions, this kit aims to provide higher wind resistance and more durable anchoring than basic straps. It’s best considered for users who regularly park in breezy spots, travel in regions with gusty winds, or simply want that extra peace of mind during camping trips.
How it works in practice
The set centres on two 37 cm ground anchors with a screw-in design that can be installed by hand using the provided T-handle or via a drill with the included adapter. The full-spiral blades are intended to grip soil securely, distributing load up to 900 lbs per anchor. Pairing anchors with two extended 414 cm polyester straps and buffer springs helps absorb wind forces and reduce stress on the awning. Z-hooks are matched to Thule Omnistor fittings for a clean, secure connection.
What to know before buying
On paper, this kit offers high wind resistance and durability, which could be valuable for vehicles parked near open spaces or during unsettled weather. However, the effectiveness of ground anchors depends on soil condition and proper installation. If you’re not handy with tools, you’ll want to factor in time for installation or assistance to ensure anchors are fully seated and springs are correctly tensioned.
Practical use cases
A typical scenario: you’re camping on a soft or mixed soil site and want to minimise awning movement during a windy night. Screwing in the 37 cm anchors and threading the straps through the Thule Omnistor connection points, then letting the buffer springs take up slack, can reduce sway. It’s not a cure-all for extreme storms, but it offers a pragmatic improvement over standard strap kits when used with diligence.
What’s included
The complete kit covers two upgraded anchors with T-handle wrench and adapter, two extended securing straps, two buffer springs, and a storage bag. Everything packs into the bag for easy transport in the RV or vehicle boot.
Technical overview (brief)
It’s designed for compatibility with Thule Omnistor systems, featuring 37 cm ground anchors, 900 lbs load capacity per anchor, and 414 cm long straps. The system emphasises UV, water, and wind resistance in the strap material.
The decision in context
It makes sense if you prioritise added stability in windy conditions and have a Thule Omnistor setup. You may want to skip if your typical sites are sheltered, if soil conditions are very hard where screw-in anchors struggle, or if you’re not comfortable with a hands-on installation. Tenacity to install correctly is as important as the kit’s material strength.
FAQ
- Can I use this kit with any Thule Omnistor model? It’s designed to fit Thule Omnistor fittings, check your model’s attachment points to ensure compatibility.
- Will these anchors work in hard soil? The kit is described as suitable for hard soil, but installation effort may increase, use the T-handle or drill adapter as specified.
- How windy is 120 km/h in practice? That figure denotes the kit’s intended wind resistance on the design side, actual performance depends on site conditions and correct setup.