Lrbners 3719-03X2 1/4-Inch Y-Splitter Cable, Braided, 1-Foot, 2-Pack
Product description
At 1 foot long, each Lrbners Y-splitter gives you a compact way to route one 6.35mm female connection to two 6.35mm TS male connections. The braided cable and zinc alloy housing suit setups where a short, direct connection helps keep nearby gear organized.
Use the two-cable pack to split an instrument or audio output between compatible destinations, such as amplifiers, mixers, PA systems, or drum machines.
Tech summary
- Connector layout: 1 female 6.35mm connection to 2 male 6.35mm TS connections
- Cable length: 1 foot
- Cable construction: Braided cable with shielded design
- Connectors: Gold-plated TS connectors
- Housing: Zinc alloy
- Pack size: 2 cables
The Y configuration is made for sending a single source to two destinations, rather than combining two sources into one input. Its short length is useful on a pedalboard, at a studio desk, or in a compact live rig, where a longer cable could add slack around connected equipment. Shielding helps address interference in audio setups, while the braided exterior is suited to frequent cable handling and repositioning.
Tips for day-to-day use
Connect the female end to a compatible 6.35mm output, then connect the two male TS ends to the receiving devices. For example, a guitar pedal output can feed two amplifiers, or a synth output can be routed to an audio interface and a monitor controller. This gives you a straightforward way to place two destinations in the same signal path without assembling a longer chain of adapters.
Keep the short run close to the equipment being connected and arrange the cable so it does not cross busy walkways or pull on the jacks. The compact format is especially practical when devices sit near one another, such as on a pedalboard or at a mixer station. It also makes it easier to keep a spare splitter on hand for another compatible setup.
What’s included
The pack contains two Lrbners 1-foot 6.35mm female-to-dual-6.35mm TS male Y-splitter cables. Use one for a primary rig and keep the second available for another routing task or setup. Both cables share the same connector arrangement, so the same connection pattern applies to each.
Is it worth it?
It makes sense if you need a compact way to send one compatible 6.35mm output to two TS destinations and want two cables in the pack. Compared with piecing together a split using separate adapters and longer leads, this dedicated 1-foot Y-cable keeps the connection direct and the layout contained. It’s a practical fit for nearby audio equipment in home studios, rehearsal spaces, and live rigs, including amplifier, mixer, PA, and drum-machine setups.