BERIXDEEP 2ft LED Batten Light 18W 2-pack

This 2ft LED batten light from BERIXDEEP offers a practical, plug-in lighting solution for utility spaces where bright, daylight-coloured illumination is needed. It comes as a two-pack with an on/off switch and a UK plug, making it easy to fit under cabinets, in a garage or on a workbench to improve visibility for tasks.

Key Points

The lights deliver a cool 6500K daylight white output, useful when clear colour rendering and high contrast matter. According to the manufacturer, each 2ft tube produces around 1800 lumens at 18W, which gives noticeable brightness while keeping energy use low. The linkable design allows multiple tubes to be connected, so you can extend lighting along a ceiling run or across shelving without extra sockets. ⚡️

These tubes are rated IP65 for water resistance, which helps protect against splashes or moisture when installed in damp areas such as utility rooms or near sinks. The built-in switch and plug-in format simplify installation, because there is no hard wiring required and relocation is straightforward.

Technical Specifications

• Name: BERIXDEEP 2ft LED Batten Lights 2 Pack
• Length: 2ft / 60cm
• Power: 18W per tube
• Light output: 1800 lm per tube
• Colour temperature: 6500K (daylight)
• Ingress protection: IP65
• Extras: UK plug with on/off switch, linkable up to 30 tubes

Usage Recommendations

For best results fit these battens at a height and spacing that reduces shadowing on your work surface. In a garage or workshop, position them above benches and along ceiling lines to create even illumination. When used under cabinets, allow a short offset from the cabinet edge to avoid direct glare and to spread light across the countertop. 🔧

Consider that the 6500K colour temperature produces a cool, clinical light which is excellent for detail work but may feel stark for living spaces. Also note that the linkable cords allow many tubes in series, but check cord routing so it remains tidy and safe. 💡

Advantages

The plug-in format makes these battens a flexible option for temporary or rented spaces where running mains wiring might not be desirable. The IP65 rating and moisture protection increase the number of appropriate installation locations, and the simple on/off switch removes the need for an additional switch circuit. The ability to connect up to 30 tubes offers a scalable way to light long garages or workshops without multiple wall sockets.