Mayco Bell steering wheel cover, 14.5–15 inch

Technical details

If you mainly want to keep an existing steering wheel covered, this Mayco Bell option focuses on fit and everyday protection rather than adding a new feature to the car. It is made for standard “O”-type steering wheels with an outside diameter of 14.5–15 inches.

The cover is black and red, made from microfibre leather, and designed with a full-surround fit. Its perforated surface is intended to help with airflow and sweat absorption, while the cover is also described as anti-slip. Those details may matter on a warm drive or when your hands tend to get damp, though the listing does not provide a measured grip or breathability result.

It is intended to help shield the wheel from scratches, fading and wear. If you want to preserve the wheel you already have rather than replace it, that is the main practical appeal. It may suit you if your steering wheel falls within the stated size range and you want a covered, more tactile surface. It may not suit you if your wheel is outside that range or is not the specified “O” type.

Getting the most from it

The product information gives no vehicle-specific compatibility list, so the steering wheel’s outside diameter is the useful starting point. Measure across the wheel itself, rather than relying only on a general description of your car. The stated range is 14.5–15 inches, a close fit is central to how this cover is meant to sit.

There is also no separate requirements information, such as tools or care instructions. For a quick visual check before buying, compare the measured diameter with the range and consider whether the black-and-red colour suits your interior. The listing does not specify how to clean the microfibre leather, so avoid assuming a particular cleaning method.

Usage tips

Installation is described as a snug, hands-on fit. Centre the steering wheel, place the cover over the top, then stretch it down over both sides before pulling the bottom edge into place. The final section may take considerable force to fit securely, so allow a little time rather than trying to rush it. If it will not seat properly, stop and check the size and wheel shape instead of treating a loose fit as acceptable.

Picture fitting it while the car is parked: the top of the cover is aligned first, then each side is eased over the rim until the lower edge sits in place. That sequence follows the supplied instructions and helps explain why accurate sizing matters. A cover chosen by colour alone can be a poor fit, this one makes more sense when your measurements match its stated range.

Before deciding

The fit limitation is the key trade-off. Although the product is described as universal, the stated compatibility is for most standard-size “O”-type wheels within a specific diameter range, not every steering wheel. The manufacturer also notes that installation can be difficult because the fit is tight. The listing does not give further details about vehicle compatibility, care, or long-term wear, so those points cannot be assessed from the available information.

Before you buy

Is this cover suitable for any steering wheel? No. It is listed for most standard “O”-type wheels measuring 14.5–15 inches across the outside diameter.

Does it protect the original steering wheel? It is intended to help protect against scratches, fading and wear, but no protection test or performance measure is provided.

Is installation straightforward? The instructions describe stretching it over the wheel in stages, and note that the final fit can require considerable force. A correct size is important for a snug fit.