Lamicall Motorcycle Phone Mount for 4.7–6.7-inch Phones

Four damping springs are designed to absorb some of the vibration produced by a motorcycle engine, which may help reduce the shaking your phone experiences on the handlebars. The mount also has cushioned silicone pads at the phone’s corners and a handlebar clip with non-slip padding. Its quick-locking clamp is intended for one-handed fitting, a practical detail when you want to secure your phone before setting off. It’s a focused choice for riders who want a handlebar-mounted phone, rather than a more basic holder without a vibration-dampening mechanism.

Where it shines

The main draw is the combination of a spring-based vibration dampener and padded contact points. Lamicall says the four springs absorb vibration, while the silicone cushioning helps protect the phone from knocks and scratches. Those features are intended to reduce movement and contact with hard surfaces, they can’t guarantee that a phone or its camera will be protected in every riding condition.

The quick-release design may also be useful if you regularly take your phone off the bike between trips. For example, you can fit the phone before a ride, secure it with the clamp, and remove it again when you park rather than leaving it on the handlebars. It suits you if you want navigation visible at the bars and value a locking mechanism you can operate with one hand while stationary.

What matters most

The stated phone-size range is 4.7–6.7 inches. The clamp’s listed maximum height and width are 6.54 inches and 3.11 inches, respectively, so screen size alone may not tell you whether a particular phone will fit. The listing also gives a maximum phone thickness, but its inch and millimetre figures don’t agree, because of that discrepancy, don’t rely on that measurement to judge a close fit.

The handlebar clip is listed for bars with a diameter of 0.59–1.57 inches (15–40 mm). Check your bar diameter and the phone’s overall dimensions before choosing it. The mount is made from alloy and composite plastic, with silicone padding on the phone clamp and handlebar clip. Given its design, the vibration feature is an added layer of cushioning, not a promise of a completely shake-free ride. If you prioritize that extra dampening, this has a clear advantage over a simple rigid clamp, if you prefer a minimal holder, its springs and padded contact points may be more than you need.

Best use cases

This mount is aimed at motorcycle handlebars, with compatibility listed for a range of iPhone and Samsung Galaxy phones as well as other phones within the stated size range. It may suit a commuter who wants to glance at a route while parked or during a safe stop, then remove the phone quickly at the destination. The supplied information doesn’t establish fit for every case, accessory, or handlebar shape, so a bulky phone setup may need particular attention to the clamp measurements.

It is not worth it if your phone falls outside the listed size limits, your handlebars are outside the supported diameter range, or you don’t want a mount with a vibration-dampening assembly. For a phone that fits and a bar within range, the one-handed locking approach and cushioned contact points are the practical reasons to consider it.

Final thoughts

Choose the Lamicall if your phone and handlebar measurements match and you want a motorcycle mount with spring-based vibration absorption, silicone padding, and quick removal. Look elsewhere if the fit is uncertain or you’re after a simpler, less feature-focused holder, the unclear thickness measurement makes checking a tight fit especially important.